Skip to content
HollandLanding Garage Door Pros
Open 24/7(289) 803-1641Open 24/7

Holland Landing Garage Door Pros · Newmarket

Garage Door Remote and Keypad Programming: before you call

Garage Doors · Newmarket, Ontario

Full-glass garage door with black frames, an orange stepladder, a level, a drill and a shop vacuum on the concrete floor.

Your remote was in the visor when the car was broken into last night. So was the insurance slip with your address on it. The door still answers that remote, wherever it is now, and you would very much like it not to.

Worth answering before the call

Are you adding a control, replacing a lost one, or starting fresh after a move? Which controls fail: one remote, all remotes, the keypad, or the car buttons? Do you have a keypad outside, and does anyone still know its code?

Will unplugging the opener reset the remotes?

No. The stored controls survive a power cut or a long unplugging; the opener remembers them when power returns, and manufacturers say this plainly. Removing a control is done at the learn button, following the model's sequence, either by erasing the whole memory or, on some models, by deleting a single device through a supported wall control or app. That is reassuring after an outage and important after a lost remote.

What is the learn button and where is it?

It is a small button on the head unit, usually under the light cover on the same side as the antenna wire, sometimes on the back. Pressed briefly, it opens a window in which a remote or keypad can be added. Erasing every stored control follows that model's own sequence, which on some current openers needs more than one button. Some wall-mounted controls carry a second learn button that works the same way, and a connected app or account is managed on its own.

Call(289) 803-1641

Request a visit

Or call (289) 803-1641 · open 24/7